Model Number

1.5 and 2.0 HCL's

Our Hollow Cathode Lamps can be used on Atomic Absorption Spectrometers.

HIGH INTENSITY

Our lamps are specially designed to emit high intensity at the recommended operating currrent, resulting in low Signal-to-Noise ratio and excellent performance.

LOW OPERATING CURRENT

Glowing starting voltage:  300 V.
Radiation stability:  1% over 30 minutes.
Size: 1.5" lamps ( Diameter: 38 mm, Length: 160 mm )

Our lamps may be operated at only half of the instrument manufacturer's recommended current for sufficient intensity, resulting in long lifetime of the lamps.

DESIGN

Our lamps are specially designed to meet or exceed the requirements of various types of atomic absorption spectrometers and to provide low detection limits for your most difficult analysis.

QUALITY CONTROL

We monitor, control and inspect every single step of the hollow cathode lamp manufacturing process. The materials are carefully selected in our manufacturing to avoid spectral interference from fill gas or impurities in the cathode material.
Every lamp is thoroughly tested prior to shipment. Under same testing conditions, the radiation intensity of every lamp is equal to or better than those made by other vendors.

WARRANTY

Every lamp is covered by a standard 1-year limited warranty.
Usually, each regular element lamp carries 5000 mA-Hour warranty, such as Cu, Ni, Ca, Mg, etc., each volatile element lamp carries 3000 mA-Hour warranty, such as As, Se, Sb, Bi, Pb, Cd, etc.